Pentair EasyTouch 8 and 4 Pool and Spa Control System Manual de usuario descargar pdf (Pagina 10)

EasyTouch Load Center Installation Guide

Recommended Hydraulic Schematic for Shared Equipment System

Plumb the solar feed and return lines between the filter and the heater. Install a three-port valve

at the feed line. Use a solar valve (model SOL-2T), to allow automatic draining of the panels.

A solar booster pump should be used when the distance to the panels exceed 200 ft., or the

panels are elevated higher than 25 ft.

Glazed solar panels require a drain valve (model HW-5B) to allow draining of the panels. This

prevents damage from overheating water. Install a drain valve at the solar feed line and connect

to the pool fill line.

SCG systems only: IntelliChlor cell with check valve between the heater and valves. Refer to

IntelliChlor User’s Guide (P/N 520589) page 4 for plumbing requirements.

Equipment Location

All equipment, with the exception of the spa-side remote, must be located at least 10 ft. from the

water’s edge.

INTELLICHLOR

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Sin comentarios

Pentair EasyTouch 8 and 4 Pool and Spa Control System Manual de usuario Pagina 10